Method Editor - Teledyne ACCQPrep HP125 Installation And Operation Manual

ACCQPrep HP125
Section 5 PeakTrak

5.2.7 Method Editor

5-12
You can return to the rack and tube display by clicking
the D R
ISPLAY ACK
The M E window has several sections. The B
ETHOD DITOR
B at the top of the window gives you quick access to file opera-
AR
tions, and column data. Below the B
and the R N
TINGS UN
contains the G
RADIENT
and P D
LECTION EAK ETECTION
Button bar – The M
ETHOD
following:
• N —Click this button to open a new method file using
EW
the default method settings for the selected column.
• O — Click this button to open a method file stored
PEN
on the system's internal hard drive.
• S — Click this button to save any modifications to
AVE
the current method file. If you attempt to save modifica-
tions to a default method file, the FILES window will
open instead so you can rename the file. This preserves
the default method.
• S A — Click this button to open the F
AVE S
From this window you can rename the current method
and save it on the system's internal storage.
• E — Click this button to close the M
XIT
and return to the M
• C D —Click this button to open the COLUMN
OLUMN ATA
DATA window. This window reports information about
the column selected on the main screen.
Run Settings – The Run Settings section contains the following:
• Column —The name of the currently selected column is
displayed. If a Column Selector Valve Module is
installed, this selects the column used for the current
separation.
• Sample Name — The sample name is a text entry box in
which you can label the run. Type a unique descriptor.
PeakTrak saves the run information under this name.
Therefore, PeakTrak cannot accept any characters that
are reserved by the operating system (* ? / \, etc.). A
space can't be used in the sample name. If you do not
type a Sample Name, PeakTrak will generate a
date/time stamp for the name when you click the P
button to begin the run.
• Flow Rate — Type or select the desired flow rate for the
run. When using the Isco default column methods, the
system sets the flow rate to the configured flow rate of
the column.
• Equilibration Volume — Type or select the volume of
solvent that is pumped through the column and out the
waste port before the sample is introduced. Data is not
collected while this volume is being pumped.
button.
B
UTTON AR
. The lower part of the window
OTES
P A and settings for P
LOT REA
.
E button bar contains the
DITOR
ETHOD
W .
AIN INDOW
UTTON
are the R S -
UN ET
C -
EAK OL
window.
ILES
E
DITOR
LAY