Teledyne ACCQPrep HP125 Installation And Operation Manual page 12

ACCQPrep HP125
Section 1 Introduction
Figure 1-1 ACCQPrep HP125
1-2
ACCQPrep HP125 – This Prep HPLC system has flow rates
from 1-125 mL/min, with up to 6000 psi capability. A two com-
ponent gradient can be formed from up to six solvents. The
system includes active solvent level sensing and detection of a
full waste container. The base system includes two fraction col-
lection racks. With the optional AutoSampler up to four col-
lection racks can be used. The RFID tagged racks can be replaced
while in operation with new racks for practically limitless
fraction collection.
ACCQPrep HP125 with optional ELSD – T h i s s y st em h a s
the same high performance features as the ACCQPrep HP125
system, but includes an internal evaporative light scattering
detector (ELSD). During operation, this detector can be com-
bined with the UV (200–400 nm) or UV-vis (200–800 nm)
detection to isolate visible and UV absorbing compounds, as well
as compounds with little or no chromophores.
A C C Q P r e p H P 1 2 5 w i t h o p t i o n a l P u r I o n M a s s
Spectrometer – This system has the same features as the
ACCQPrep HP125, but includes a mass spectrometer with a
detection range of 10 to 1200 Daltons (Da) (PurIon S) or 10-2000
Da (PurIon L systems). During purification, this system can be
combined with the UV (200 - 400 nm) or UV-V (200 - 800 nm)
detector to isolate visible and UV absorbing compounds, as well
as compounds with specific molecular weights or mass ranges.