Teledyne ACCQPrep HP125 Installation And Operation Manual page 108

ACCQPrep HP125
Section 6 Maintenance
Figure 6-5 Location of screws on the stator retainer
Figure 6-6 Removing the rotor
Figure 6-7 Sealing surface of the stator
6-8
Gap will
appear here
Screws
2. Remove the screws and pull the stator outward. This may
require a side-to-side motion until removed.
3. When the stator is removed, use your finger or a small tool
to pry the black plastic rotor out of its recess (Figure 6-6).
4. Usually the failure mode is a visible scratch between the
normal passages on the rotor.
Rotor
Sealing surface