Teledyne ACCQPrep HP125 Installation And Operation Manual page 74

ACCQPrep HP125
Section 5 PeakTrak
5-10
Spaces are not allowed in the name. If you do not type a
Sample Name, PeakTrak will generate a date/time
stamp for the name when you click the P
begin the run.
• Flow Rate — Type or select the desired flow rate for the
run.
• Detector — Controls the current peak detection mode.
To change the peak detection settings, open the M
E window.
DITOR
• Solvents A and B— If the system doesn't have the
Solvent Selector Valve Module, you can select a solvent
name from the drop down list. The solvents in the list
are those defined by the C
Solvent Selector Valve Module is installed, this control
allows you to select a solvent for use in the current
separation.
Run Control Buttons – From left to right, the control
buttons are:
• P — The P
LAY LAY
After a run has started, this button is replaced by the
Pause button.
• P — The P
AUSE AUSE
value while the system continues to operate (sometimes
called an isocratic hold).
Note
Pausing the run extends the run length. While in the paused
state, you can resume the gradient by clicking the P
or stop the run by clicking the S
run, the system continues the gradient curve from the %B
when the system was paused.
• S — This button suspends the entire run. Unlike the
TOP
Paused state, the pump, peak detection, and fraction
collection will not operate. While stopped, you can abort
the run by clicking the R
buttons, or resume the run by clicking the clicking the
P button. In either case, the data is always saved.
LAY
Using the F F
AST
way to abort a run because this runs sample probe wash
and cone cleaning routines (PurIon systems only) to
clean the system for another run.
• N T — This button advances the fraction
EXT UBE
collector to the next tube position. This allows you to
conveniently collect eluant of interest in new tube.
• R — This button is active when the system has
EWIND
completed the run, or if the run was Stopped by clicking
the S button. If you want to terminate the separation
TOP
prematurely the F
The R button returns you to the M
EWIND
ONFIGURATION
button starts or resumes the run.
button holds the %B at the current
button. If you resume the
TOP
or F F
EWIND AST
button is the recommended
ORWARD
F button is recommended.
AST ORWARD
button to
LAY
ETHOD
window. If the
button,
LAY
ORWARD
window.
AIN