Installing The Autosampler - Teledyne ACCQPrep HP125 Installation And Operation Manual

ACCQPrep HP125
Section 2 Installation
2.4 Installing the
AutoSampler
Figure 2-15 AutoSampler Module and Z-Drive
2-10
Connect the included check valve(209016629) to the inject valve
waste line. Ensure that the arrow on the check valve points
toward the waste container. This check valve ensures sample
doesn't run from the port when the injection syringe is removed.
If an AutoInjector or AutoSampler is installed and manual
injection is also desired, install the included check valve
(209016629) in the waste line from either the inject valve (if no
AutoInjector or AutoSampler is installed) or the waste line from
the sample load pump. Ensure that the arrow on the check valve
points toward the waste container. This check valve ensures
sample doesn't run from the port when the injection syringe is
removed.
These instructions assume that the AutoSampler was purchased
with a new ACCQPrep. In that case, the AutoInjector portion of
the AutoSampler is already installed in the ACCQPrep. If not,
please refer to installation instructions included with the AutoIn-
jector.
To install the AutoSampler:
1. Carefully unpack the Z-Drive and remove the packing
materials from the Y-axis arm (Figure 2-15).
2. Find the Y-axis carriage on the arm of the AutoSampler
Module. The Z-Drive will be attached to this carriage (Fig-
ure 2-16).