Autoinjection Operating Steps - Teledyne ACCQPrep HP125 Installation And Operation Manual

Figure 4-3 Viewing injections
4.3.2 AutoInjection
Operating Steps
6. At the completion of the sequence, the final separation
results will be displayed. To easily view previous separa-
tions, press the R
7. Select F | O
ILE PEN
If a sample had multiple injections, the run sequence will be dis-
played under a single name preceded by a "+" symbol. This
symbol indicates there are multiple injections with the same
base file name. Names are appended with "-I(#)" to signify the
numerical order of the separation. For example:
• If you have a single injection run it can be named A01.
• For multiple injections, the first injection can be named
A03-I1, the second can be A03-I2, and the third can be
named A03-I3.
8. Select the file you wish to display.
9. The remaining injections can be immediately viewed by
pressing the left or right arrows at the lower left and right
of the file viewer screen. This function can also be used to
immediately view files before or after the currently viewed
file even if they are not part of the same injection sequence.
This section outlines the steps performed by the AutoInjector
during sample injection.
1. You are prompted to place the sample probe into the sam-
ple container before the separation begins.
2. During column equilibrium, the sample loop is first placed
into the run position. This position passes the column
equilibration fluid through the loop to wash out any left-
Section 4 Operation
key to return to the H
EWIND
to view previous separations.
ACCQPrep HP125
screen.
OME
4-5