Acura NSX 1997 Service Manual page 108

Main Menu
Engine Block
Illustrated Index
Lubricate all internal parts with engine oil during reassembly.
NOTE:
• Apply liquid gasket to the mating surfaces of the left
side cover and oil pump case before installing them.
• Use liquid gasket, part No. 08718-0001 or 08718-
0003.
DRIVE PLATE (A/T)
Check for cracks.
SPECIAL WASHER
12 x 1.0 mm
74 N-m (7.5 kgf-m, 54 Ibf-ft)
Torque sequence, page 7-6
12 x 1.0 mm
103 N-m (10.5 kgf-m, 76 Ibf-ft)
Torque sequence, page 7-6
CRANKSHAFT OIL SEAL
Installation, page 7-18
Replace.
SPECIAL BOLT
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
Replace.
Table of Contents
6 x 1.0 mm
COVER
14 N-m (1.4 kgf-m, 10 Ibf-ft)
COVER
FLYWHEEL (M/T)
Runout, section 12
LEFT
SIDE COVER
Apply liquid gasket
to mating surface.
• If the bottom of the oil pan is deformed, it should
be repaired or the oil pan should be replaced re-
tain proper clearance between the screen and
the bottom.
OIL PAN
• Do not deform
the bottom.
• Refer to page 8-10
when installing.
OIL PAN GASKET
Replace
BAFFLE PLATE
OIL SCREEN
O-RINGS
Replace.
DOWEL PINS
OIL PASS
PIPE/JOINT
OIL PUMP
Overhaul, page
Removal/Inspection,
page 8-8
Apply liquid gasket
to mating surface.
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
O-RING
Replace.
CRANKSHAFT
OIL SEAL
Installation, page
Replace.
SPECIAL BOLTS
8-7
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
Replace.
SPECIAL BOLTS
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
Replace.
8-9