Rocker Arms - Acura NSX 1997 Service Manual

Main Menu

Rocker Arms

Installation
Install the rocker arms in the reverse order of removal:
• Valve adjusting locknuts should be loosened and
adjusting screws backed off before installation.
• The component parts must be installed in the
original locations.
1. Install the lost motion assemblies.
2. Install the rocker arms while passing the rocker arm
shaft through the cylinder head.
RUBBER BAND
ROCKER ARMS
ROCKER SHAFT
3. Install the orifices. If the holes in the rocker arm
shafts and the cylinder head are not in line with
each other, use a 12 x 1.25 mm bolt in the rocker
arm shaft to rotate the shaft.
O-RING
Replace.
CAUTION:
• After installing the rocker shaft orifice, try to turn
the rocker shaft to make sure that the orifice has
been inserted in the hole of the rocker shaft cor-
rectly. If the orifice is in place, it should not turn.
• Remove the rubber bands after installing the
rocker arms.
Table of Contents
ROCKER SHAFT
ROCKER SHAFT
OIL CONTROL
ORIFICES
Clean.
O-RING
Replace.