Internal Or Removable 2.5" Sata Hdd/Ssd - Kontron KBox C-102 Series User Manual

13.1.2. Internal or Removable 2.5" SATA HDD/SSD

Depending on the ordered system configuration, your KBox C-102-1 can be equipped with one 2.5" SATA removable
drive bay (refer to Figure 61, "DRIVE 1") or one internal mounting frame for 2.5" SATA HDD/SSD.
The internal 2.5" HDD/SSD is not accessible from the outside. The internal SATA HDD/SSD is installed (always factory
installed) into the system by the use of a mounting frame.
The drive bay (DRIVE 1) for removable 2.5" SATA HDD/SSD is accessible from the front side of the system.
This interface of the KBox C-102-1 system (if internal or external accessible) supports speeds of up to SATA 6 Gb/s.
This SATA interface supports hot-swapping.
To prevent data loss, don't remove the HDD/SSD during read/write activity [while the
"DRIVE LED" (Figure 18) is flashing green].
Your KBox C-102-1 can be equipped with one drive bay for a removable HDD/SSD (refer to
Figure 61, "DRIVE 1") or one internal mounting frame for a 2.5" SATA HDD/SSD.
If the KBox C-102-1 configuration with internal 2.5" SATA HDD/SSD was ordered, the
"DRIVE 1" for removable 2.5" SATA SATA HDD/SSD is not available on the front side of the
system; refer to Figure 9, under consideration of the system design (Figure 61, Figure 62) and
mechanical differences (see 16.1.5 and 16.1.6).
Refer also to the area marked "D" in the section 4.4.
www.kontron.com
KBox C-102 - User Guide, Rev. 1.0
// 74