Table of Contents
Advertisement
6.3.7. Installing/Removing an mSATA SSD
To install an mSATA SSD please proceed according to the steps described:
1.
Close all applications; shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the device as described in the subsection 6.2 "Opening and Closing the KBox C-102" (step 1-6).
3.
Locate the mSATA sockets and the corresponding fixing clips. (Figure 37, pos. 8).
4.
Insert the mSATA SSD card into the corresponding socket (Figure 37, pos. 7) at an angle of approx. 45° and push it
down until the fixing holes of the card are aligned with the fixing clips.
5.
Press the mSATA SSD down (on the side with the fixing holes) until the mSATA SSD snaps in the fixing clips.
6.
In order to close the KBox C-102, proceed in reverse order (step 6 to 1 of the section 6.2).
To remove an mSATA SSD please proceed according to the steps described:
1.
Close all applications; shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the device as described in the subsection 6.2 "Opening and Closing the KBox C-102" (step 1-6).
3.
Locate the mSATA SSD card installed into your system.
4.
Slide outwards the fixing clips in order to release the mSATA SSD. It will spring up at an angle of approx. 45° on
the fixing clips side.
5.
Gently pull the mSATA SSD card out.
6.
In order to close the KBox C-102, proceed in reverse order (step 6 to 1 of the section 6.2).
Preventive Maintenance for SSD drive:
Because of the limited predetermined lifespan of SSDs, we recommend to check the
condition of your installed SSD drives via S.M.A.R.T. regularly.
Pay attention to the manufacturer specifications for lifespan.
www.kontron.com
KBox C-102 - User Guide, Rev. 1.0
// 52
Advertisement
Table of Contents
