Table of Contents
Advertisement
8.4.1 SATA Flash Module Installation
A SATA Flash module may be connected to the CP6005(X)-SA via the onboard connector, J16. This op-
tionally available module must be physically installed on the CP6005(X)-SA prior to installation of the
CP6005(X)-SA in a system. During installation it is necessary to ensure that the SATA Flash module is
properly seated in the onboard connector J16, i.e. the pins are aligned correctly and not bent.
8.4.2 Installation of External SATA Devices
The following information pertains to external SATA devices which may be connected to the CP6005(X)-
SA via normal cabling.
Some symptoms of incorrectly installed SATA devices are:
»
Device on a SATA channel does not spin up: check power cables and cabling. May also result
from a bad power supply or SATA device.
The SATA connector on the CP6005(X)-SA provides only a data connection. The power for this
device must be supplied by a separate connector. For further information, refer to the re-
spective documentation of the device.
»
SATA device fail message at boot-up: may be a bad cable or lack of power going to the drive.
8.4.3 Onboard 2.5" HDD/SSD Installation
One 2.5" SATA HDD/SSD may be directly connected to the board via the adapter module MMADP-SATA01
and the J16 connector. This module is required to provide SATA interfacing to the HDD / SSD. For fur-
ther information regarding the MMADP-SATA01 module, refer to Chapter 6.
8.4.4 PMC Module Installation
The CP6005(X)-SA supports the installation of a PMC module via the J20 to J21 connectors. For infor-
mation on the installation of the PMC module, refer to the documentation provided with the module.
8.4.5 XMC Module Installation
The CP6005(X)-SA supports the installation of an XMC module via the J19 connector. For information
on the installation of the XMC module, refer to the documentation provided with the module.
8.4.6 Rear Transition Module Installation
For physical installation of rear transition modules, refer to the documentation provided with the mod-
ule itself.
8 . 5 B a t te r y Re p l a c e m e n t
The CP6005(X)-SA RTC may be backed up using a single UL-approved CR2025, 3.0 V "coin cell" lithium
battery from one of three possible points of installation:
»
onboard
»
on the rear transition module
Only one battery may be installed at a time. Refer to Table 1 for battery requirements.
www.kontron.com
User Guide
CP6005(X)-SA
69
Advertisement
Table of Contents
