Top Cover; Figure 33: Inside Of The Top Cover With Centering And Fixing Brackets - Kontron KBox C-102 Series User Manual

6.1. Top Cover

The pictures in this section correspond to a KBox C-102-2 system.
The cover description can be applied to all system variants, under consideration of the
different mechanical specifications of the KBox C-102; refer to the section 16.1 "Mechanical
Specifications of the KBox C-102".
When used as intended the KBox C-102 is to be operated only in closed condition.
Only when the right side cover is fixed with the screws (Figure 23, pos. 2) and top cover is
properly installed and secured with the knurled screws (Figure 59, pos. 2) on the front side,
it is ensured that the user doesn't have access to the internal components of the KBox C-102
during operation.
The cover will be fixed to the chassis using the centring bracket at the rear side of the cover (Figure 33, pos. 3) and the
fixing bracket with captive knurled screws at the front side of the cover (Figure 33, pos. 5).
When inserting the cover, make sure that:
 At the rear: the centring bracket (Figure 33, pos. 3) is inserted properly into the corresponding cover retaining
bracket of the chassis (Figure 38, pos. 13).
 At the front side: the fixing bracket with captive knurled screws of the cover (Figure 33, pos. 5), is matching
properly over the cover retaining bracket on the front side (Figure 38, pos. 1).
The fixing bracket with captive knurled screws (Figure 33, pos. 5) secures the top cover on the front side (Figure 59,
pos. 2).

Figure 33: Inside of the top cover with centering and fixing brackets

1
1 Inside of the top cover
2 Rear part of the top cover
www.kontron.com
2
3 Centering bracket (on the rear side)
4 Air exhaust openings
5 Fixing bracket with knurled screws on the front side
5
KBox C-102 - User Guide, Rev. 1.0
4
3
// 44