Control Cabinet Mounting; Figure 43: Keep Out Area For Mounting Around Kbox C-102-4 (Front Side View Without Fan Tray); Figure 44: Keep Out Area For Mounting Around Kbox C-102-4 (Front Side View With Optional Fan Tray) - Kontron KBox C-102 Series User Manual

8.1. Control Cabinet Mounting

Please observe the "General Safety Instructions for IT Equipment" (included) and the
installation instructions (refer to the chapters 1/ and 8/).
Your KBox C-102 is supplied with assembled mounting brackets. The key holes of the upper and lower mounting
brackets (Figure 27, pos. 1 and pos. 3) allow you to mount the KBox C-102 to a mounting side of the control cabinet in
vertical position. This is the only permitted operating position.
For a sufficient air circulation around the device, we recommend not to place (mount) or
operate any other devices within the "keep out area". The clearances of "50mm" and
"100mm" around the KBox C-102 must be observed; refer to the marked areas in Figure 43 to
Figure 49.
Figure 43: Keep out area for mounting around
KBox C-102-4 (front side view without fan tray)
Prepare the mounting surface with four screws and if necessary anchors corresponding to the mounting surface type
(fire-resistant material). Please refer to the information for mounting to the section 16.1, "Mechanical Specifications
of the KBox C-102", and the subsections 16.1.1 / 16.1.4 / 16.1.5 / 16.1.6 and 16.1.7, or refer to the drawings for
KBox C-102 on our web site. The drawings can be downloaded from our web site www.kontron.com by selecting the
product.
www.kontron.com
Figure 44: Keep out area for mounting around
KBox C-102-4 (front side view with optional fan tray)
KBox C-102 - User Guide, Rev. 1.0
// 56