Table of Contents
Advertisement
8/ Installation Instructions
The KBox C-102 comes with attached wall mount brackets. The available mounting key holes (Figure 27, pos. 1 and
pos. 3) of the wall mounting brackets allow the unit attaching to a wall of a fire resistant enclosure.
Expansion card installation should be performed before installing the KBox C-102 into the
control cabinet.
Whenever possible, unpack or pack this product only at EOS/ESD safe work stations. Where
a safe work station is not guaranteed, it is important for the user to be electrically
discharged before touching the product with his/her hands or tools. This is most easily done
by touching a metal part of the system chassis.
Do not handle this product out of its protective enclosure while it is not used for operational
purposes unless it is otherwise protected.
Prior any installation work ensure that there are no live wires on the installation site
Do not handle the device if there is any damage visible.
Do not operate the KBox C-102 with foreign objects inside the chassis.
Further do not insert any retrieval device into the device while it is connected to power.
Kontron rejects all liability for any and all damages resulting from operation of the unit with
foreign objects inside the chassis.
The KBox C-102 has to be installed and operated only by trained and qualified personnel.
The KBox C-102 system is designed for usage within control cabinets only.
Only personnel with appropriate qualifications, trainings and authorization are permitted to
install and work with the Kontron KBox C-102.
This device shall only be installed in or connected to systems that fulfill all necessary
technical and specific environmental requirements.
The KBox C-102 system is designed to be operated in vertical position with attached
mounting brackets as shown in Figure 8 and Figure 9. It is not allowed to install the KBox C-
102 as a stand-alone (desktop) device.
Do not remove the wall mounting brackets.
The unit must be placed such that there is sufficient space in front of it for connecting the
cables to the
I/O interface connectors and for operating the power button.
Leave sufficient free space around the unit to prevent the device from possibly overheating!
To ensure proper operation, we recommended free space as specified below:
See also Figure 43 to Figure 49 section 16.1 "Mechanical Specifications".
It must be observed that all ventilation openings are not covered/obstructed by objects.
The KBox C-102 must be firmly attached to a clean flat and solid mounting surface. Use
proper fastening materials suitable for the mounting surface. Ensure that the mounting
surface type and the used mounting solution safely support the load of the KBox C-102 and
the attached components.
Please follow the local/national regulations for grounding.
The voltage feeds must not be overloaded. Adjust the cabling and the overcurrent protection
to correspond with the electrical figures indicated on the type label.
The type label is located on the right side of the system.
It is recommended that the last cable attached to the system should be the power cable!
Refer to the section 8.2 "DC Power Plug Terminal" and chapter 9/ "Starting Up".
www.kontron.com
above and below: 100 mm (3.937")
left and right: 50 mm (1.96").
KBox C-102 - User Guide, Rev. 1.0
// 55
Advertisement
Table of Contents
