Kontron KBox C-102 Series User Manual page 86

Sub-Screen Function
Lock Legacy
Resources>
ACPI settings>
(continued)
S3 Video
Repost>
Miscellaneous> Watchdog>
Additional Information two-staged watchdog
Programmable stages to trigger different actions - If one stage is disabled, then the next stage
is also disabled.
Common actions for a watchdog trigger events 'Delay', 'Reset' and 'Watchdog signal only'
CPLD code allows for triggering NMI or SCI. This needs programming of a predefined action
inside the BIOS and therefore can only be used in a customized BIOS solution.
Timeouts that can be set to eight different fixed values between 1 second and 30 minutes.
Reset Button
Behavior>
I2C Speed>
On-board I2C
Mode>
Manufacturing
Mode>
LID Switch
Mode>
Sleep Button
Mode>
ACPI
Temperature
Polling>
PCI
ExpressCard 0>
PCI
ExpressCard 1>
SMART Smart Self Test>
Settings>
H/W Monitor> CPU
Temperature>
Module
Temperate>
www.kontron.com
Second level Sub-Screen / Description
Enables or disable lock of legacy resources
[Enabled, Disabled]
Enables or disables S3 video repost
[Enabled, Disabled]
Auto Enables automatic reload of watchdog timers on timeout
Reload>
[Enabled, Disabled]
Global Enable sets all Watchdog registers (except for WD_KICK) to
Lock> read only, until board is reset. [Enabled, Disabled]
Stage 1 Selects action for this Watchdog stage
Mode>
[Disabled, Reset, NMI, SCI, Delay, WDT Signal only]
Selects reset button behavior
[Chipset Reset, Power cycle]
Selects internal I2C bus speed between (1 kHz and 400 kHz)
[200 kHz]
Keep 'Multimaster' setting unless otherwise noted
[MultiMaster, BusClear]
Read only field
[Disabled]
Shows or hides Lid Switch Inside ACPI OS. The default setting is disabled.
[Disabled, Active normal, Active inverse]
Shows or hides Sleep Button inside ACPI OS. Default setting is disabled.
[Enabled, Disabled]
Sets mode used for temperature polling through the OSPM
(0 is disabled and 1 enabled9.
[Enabled, Disabled]
Controls PCIe port for ExpressCard support
If not used, keep in the disabled state.
[Port 1, Port 2, Port 3, Port4, Disabled]
Controls PCIe port for ExpressCard support
If not used, keep in the disabled state.
[Port 1, Port 2, Port 3, Port4, Disabled]
Run Smart Self Test on all HDDs during POST
[Enabled, Disabled]
Read only field
Displays CPU temperature in °C
Read only field
Displays module temperature in °C
KBox C-102 - User Guide, Rev. 1.0
// 86