Kontron KBox C-102 Series User Manual page 101

Function Second level Sub-Screen / Description
HD Audio HD Audio>
Configuration>
Audio DSP>
HDA-Link Codec Select>
iDisplay Audio
Disconnect>
PME Enable>
HD Audio Advanced
Configuration>
ETH (X102)> Enable/Disable ETH (X102)
[Enabled, Disabled]
Wake on LAN Enable/Disable ETH (X102) to wake the system.
Enable>
If ME is on in the Sx state, Wake On Lan cannot be disabled.
[Enabled, Disabled]
ETH (X103)> Enable/Disable ETH (X103)
[Enabled, Disabled]
ETH (X104)> Enable/Disable ETH (X104)
[Enabled, Disabled]
SD Card Enable/Disable this USB physical connector (physical port).
controller>
Once disabled, any USB devices plugged into the connector will not be detected by BIOS or
OS.
[Enabled, Disabled]
www.kontron.com
Controls detection of the HD-Audio device
Auto enables HD if present or disables if not present otherwise
HD Audio is unconditionally enabled or disabled
[Enabled, Disabled, Auto]
Enables or disables audio DSP
[Enabled, Disabled]
Selects the codec
Platform on-board codec (single verb table) or
External codec kit (multiple verb table )
[Platform Onboard, External Kit]
Disconnects SDI2 signal to hide/disable iDisplay audio codec
[Enabled, Disabled]
Enables PM wake of HD audio controller during post.
[Enabled, Disabled]
I/O Buffer Selects the ownership of the I/O buffer between
Ownership> Intel HD audio link and I2S port (for bilingual
codecs).
[HD-Audio Link, HD-Audio Link/I2S Port,
I2S Port]
I/O Buffer Selects the voltage operation mode of the I/O
Voltage buffer
Select>
[3.3 V, 1.8 V]
HD Audio Link Selects HD audio link frequency
Frequency>
Applicable only if HDA codec supports selected
frequency.
[6 MHz, 12 MHz, 24 MHz]
iDisplay Link Selects iDisplay Link frequency.
Frequnecy >
Applicable only if iDisp codec supports selected
frequency.
[48 MHz, 96 MHz]
KBox C-102 - User Guide, Rev. 1.0
// 101