Table of Contents
Advertisement
Figure 27: CP3005-SA 8HP with MMEXT-XMC02 Module
12.3.1. Installation of External SATA Devices
The following information pertains to external SATA devices which may be connected to the CP3005-SA via normal
cabling.
Some symptoms of incorrectly installed SATA devices are:
Device on a SATA channel does not spin up: check power cables and cabling. May also result from a bad power
supply or SATA device. The SATA connector on the CP3005-SA provides only a data connection. The power for
this device must be supplied by a separate connector. For further information, refer to the respective
documentation of the device.
SATA device fail message at boot-up: may be a bad cable or lack of power going to the drive.
12.3.2. 2.5" HDD/SSD Installation
One 2.5" SATA HDD/SSD may be connected to the CP3005-SA. The HDD/SSD may be connected to the 8HP CP3005-SA
board version equipped with an MMEXT05 extension module via the SATA connector J6 located on the extension
module. Please refer to Figure 26: HP CP3005-SA with MMEXT-XMC02 Module for the placement of the 2.5" HDD/SSD.
12.3.3. XMC Module Installation
The 8HP CP3005-SA equipped with the MMEXT-XMC02 module provides an XMC connector, J1, for connection to an
XMC module such as the Kontron XMC 401, XMC402, etc.
The XMC module must be installed on the MMEXT-XMC02 prior to installation of the CP3005-SA with the MMEXT-
XMC02 in a system.
Before installing an XMC module on the CP3005-SA equipped with an MMEXT-XMC02 extension module, ensure that
the safety requirements on page 75 are observed.
www.kontron.com
CP3005-SA – Rev. 0.6 Preliminary
// 78
Advertisement
Table of Contents
