Table of Contents
Advertisement
4.4.6. SDCARD Slot
This slot, marked "SDCARD" is an SDHC/SDXC compliant interface realised using a standard SD card connector. It is
accessible at the front side of the KBox C-102 (Figure 59, Figure 61 and Figure 64) and is located between the serial
interface (RS232/X110) and DISPLAYPORT (X109).
This SD card reader supports SD, SDHC and SDXC cards.
SD card activity is indicated by the SD LED on the KBox C-102 front side.
This interface permits hot-plugging of the SD card. The system can also be booted from this interface.
Figure 15: SDCARD slot
This interface supports hot-plugging.
To prevent data loss when removing the SD/SDHC/SDXC card, it may not be removed during
a read or write access [while the SD LED (Figure 18) is flashing].
To install a card please perform following steps:
1.
Insert the SD/SDHC/SDXC card into the SDCARD slot marked "SDCARD" (see Figure 59 and Figure 15) on the front
side of the KBox C-102.
2.
Gently push the card into the slot until it snaps into place. When the card was inserted correctly, the
SD LED (Figure 18) lights up.
Do not act with force when inserting the memory card. If the card is not inserted properly in
the guide rails, remove the card from the slot and re-insert it with care.
3.
The card is ready for use.
To remove a card, proceed as described below:
1.
Gently push the SD/SDHC/SDXC card until it clicks.
2.
Release the card and it will be partially ejected.
3.
Pull the card out from the slot.
4.4.7. X110 - RS232 Port
The RS232 interface (X110, Figure 59, Figure 61 and Figure 64) is provided as a 9-pin D-SUB connector. It allows you to
connect a serial device to the system.
For pin assignment refer to subsection 18.1.6.
www.kontron.com
KBox C-102 - User Guide, Rev. 1.0
Figure 16: SD card (not included)
// 30
Advertisement
Table of Contents
