VX3030 User's Guide
2.7.1
USB or SATA NAND drive Flash Device Installation
The onboard USB or SATA device is used to connect an USB Flash Disk.
The NAND Flash module is fixed to the board, by using on one side the connector, and on the other side, a nylon
screw mounted on the VX3030 heatsink.
Make sure to use a nylon screw when installing the NAND Flash module, not to damage the VX3030
heatsink. Kontron Order Code: VIS-CLS-M3X6-NYLON. Radiospare Reference: 527-971.
CA.DT.A87-5e
9
USB
10
Figure 11: USB or SATA Mezzanine Slots Location
Main Characteristics:
Cheese head screw
M3x6mm
Nylon
Operating range: -40°C - +158°C
1
2
Installation
Page 25