Table of Contents
Advertisement
Standard Front Panel:
The following interfaces are available with the KBox C-102:
24VDC input power (X101)
3x Gigabit Ethernet (X102, X103, X104)
2x USB 3.0 (X105, X106)
2x USB 2.0 (X107, X108)
DisplayPort (X109)
SD Card slot (without X numbered slot)
RS232 serial (X110)
Buttons with corresponding LEDs:
RSQ (rescue)
PWR (power)
LEDs:
GP1 to GP4 (general purpose LEDs)
THERM (thermal status)
DRIVE (SSD/HDD drive status)
SD (SDHC/SDXC status)
WD (Watchdog status)
Standard Baseboard - Onboard and System Expansion Capabilities:
up to 2x SATA and power connector (for internal or removable devices, depending on the KBox C-102
configuration)
2x mSATA sockets
2x Mini PCIe x1 sockets (one socket is on the top side, the second one on the bottom side of the baseboard)
1x PCIe x8 socket for expansion via riser cards:
up to 4x PCIe x4 sockets on riser card (depending on the KBox C-102-4/-2/-1 configuration) or
1x PCI (32 bit) and 1x PCIe x4 sockets on riser card (available for KBox C-102-2 only)
Optional System Extension:
RS232/RS422 Port: via internal factory mounted and configured RS232/RS422 adapter module
CAN Port: via internal factory mounted CAN adapter module
DisplayPort or Long Distance Solution (LDT3) (via corresponding internal factory mounted adapter modules)
Optional external accessible RTC lithium battery
Optional system extension with fan tray (not possible for KBox C-102-0)
Profibus or Profinet Fieldbus support: via internal factory mounted adapter module
The KBox C-102 has a compact aluminum chassis with cooling fins and is also available a fanless system (basic
version without additional fan only!)
The rated voltage range of the mains can be found on the type label. The type label is located at the right side of the
device (Figure 23, pos. 9).
The KBox C-102 is designed to be operated wall mounted inside a control cabinet, in vertical
position, except with the top side facing down.
When you power on the KBox C-102, make sure that the air exhaust openings on the top side
(Figure 25, pos. 12), the air intake openings on the bottom side (Figure 26, pos. 11) and the
cooling fins of the chassis (Figure 24, Figure 25 and Figure 26, pos. 6) are not obstructed
(covered) by any objects.
To provide sufficient heat dissipation via the cooling fins of the device, do not cover the
cooling fins of the KBox C-102. Do not place any objects on the device. When installing the
system, please observe the clearance recommendation (keep out area) in the subsection 8.1
"Control Cabinet Mounting"; refer to the marked areas in Figure 43 to Figure 49.
www.kontron.com
KBox C-102 - User Guide, Rev. 1.0
// 23
Advertisement
Table of Contents
