Table of Contents
Advertisement
5.1. (X204) - Serial Port RS232/RS422
This port can be only factory installed and configured.
When you order the KBox C-102 with this extended interface via RS232/422 adapter module,
you have to specify in your ordering:
Your KBox C-102 can be extended, via an adapter module, with an additional serial interface RS232/RS422. This serial
port (Figure 28, Figure 29, pos. 1) is available as 9-pin D-SUB connector (male), marked as "SERIAL" on the front side
of the system. It must be factory configured as RS232 or RS422 corresponding your ordered port configuration. The
serial port will be configured via an on-board DIP switch (SW1) for RS232 or RS422 serial communication.
Your system order with RS422 port must also contain the specification about the termination resistor (120Ω). If your
application requires the termination resistor, it must be enabled at factory only. The corresponding DIP switch is not
accessible for end user. For pin assignment refer to subsection 18.2.3.
5.2. (X203) - CAN Port
Your KBox C-102 can be extended via an adapter module with a CAN port, that allows you CAN Bus communication.
The optional CAN port (Figure 28, Figure 29, pos. 2) is implemented as a sub-D 9 pin connector (male). This port is
galvanically isolated (500V).
For pin assignment refer to the section 18.2.4.
If a termination resistor (120Ω) is required, you have to make a connection (bridge) between
pin 1 and 2, respectively pin 7 and pin 8, in order to enable the onboard termination resistor
(120Ω).
5.3. (X 201 or X202) - DP 2 DisplayPort or LDT3 Port
Your KBox C-102 can optionally be extended with a LDT3 interface or a second DisplayPort (DP 2).
Only one of these two interfaces (LDT3 and DP 2) can be ordered as optional extension of
your KBox C-102 system.
5.3.1. (X202) – DisplayPort 2
The DP 2 port is a DisplayPort compliant interface realized using a standard DisplayPort connector. An external
(digital) display can be connected to the DisplayPort connector (DP 2) (Figure 28, Figure 29, pos. 3).
For pin assignment refer to subsection 18.2.2.
5.3.2. (X201) – LDT3 Port
The LDT3 is an extension board for the KBox C-102 wich implements a HDBaseT 2.0 transmitter for video and USB 2.0
signals. The HDBaseT standard can be used to extend the distance between a computer and a monitor of up to 150
meters, depending on the resolution and the cable quality. HDBaseT is also known as IEEE1911.
For pin assignment refer to subsection 18.2.1.
www.kontron.com
the needed configuration of this port as RS232 or RS422 and
for RS422 configuration: if the onboard termination resistor (120Ω) should be enabled or
disabled.
KBox C-102 - User Guide, Rev. 1.0
// 39
Advertisement
Table of Contents
