Graphics Interfaces; Sata; Audio Interfaces - Kontron COMh-caRP User Manual

COM-HPC connector ADL P
USB2 USB2 3 In corresponding with USB_SS2
USB3 USB2 4 In corresponding with USB_SS3
USB4 USB2 5 -
USB5 USB2 6 -
USB6 USB2 7 -
USB7 USB2 8 -
- USB2 9 Not used
- USB2 10 Not used
Table 16: USB 2.0 ports

3.4.5 Graphics Interfaces

COM-HPC Client boards support following graphic interfaces:
Interface Description
eDP embedded DisplayPort
DP0 DisplayPort 0
DP1 DisplayPort 1
DP2 DisplayPort 2
Table 17: COM-HPC defined display interfaces
If more than one active display port is connected, then the processor frequency may be
lower than base frequency in thermally limited scenarios.
COMh-caRP supports the full range of COM-HPC addressed graphic interfaces. Additionally there is
also graphical use of both USB4 interfaces possible.
COMh Port ADL Port Remarks
eDP/DSI DDIA eDP is default, DSI only with custom version possible
DDI2 (DP++) DDIB -
DDI0 (DP++) TCP0 -
DDI1 (DP++) TCP1 -
USB4 0 TCP2 -
USB4 1 TCP3 -
Table 18: Display Interfaces on COMh-caRP

3.4.3 SATA

Two SATA links for support of SATA-150 (revision 1.0, 1.5Gb/s), SATA-300 (revision 2.0, 3Gb/s), and
SATA-600 (revision 3.0, 6Gb/s) devices are defined, for the Client Module and the Server Module.

3.4.6 Audio Interfaces

www.kontron.com
Description
COMh-caRP User Guide
20/60