Installing/Removing Pci/Pcie Expansion Cards (For Kbox C-102-4/-2/-1 Only); Figure 40: Detail Of The Kbox C-102-2 With Pcie Riser Card With 2X Pcie X4 Sockets; Figure 41: Detail Of The Kbox C-102-2 With Pci-Pcie Riser Card With 1X Pci (32 Bit) And 1X Pcie X4 Sockets; Figure 42: Detail Of The Kbox C-102-4 With Pcie Riser Card With 4X Pcie X4 Sockets - Kontron KBox C-102 Series User Manual

6.3.5. Installing/Removing PCI/PCIe Expansion Cards (for KBox C-102-4/-2/-1 only)

The PCI/PCIe expansion cards can be installed into the slots on the front side of the system (Figure 59/Figure 61). The
slots are marked with "PCIe 1" to "PCIe 4". It is recommended to expand your KBox C-102 with PCI/PCIe cards before it
is installed into a control cabinet.
1. Close all applications; shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2. To have access to the PCI/PCIe sockets you have to open the KBox C-102-4/-2/-1 as described in the section 6.2
"Opening and Closing the KBox C-102" (step 1-6).
3. To remove/install an expansion card, you have to remove the corresponding card/slot bracket (refer to
Figure 59/Figure 61 and Figure 40/Figure 41). Loosen the corresponding fastening screw on the internal side,
which secures the slot/card bracket and remove it. Retain the screw for later use (refer to Figure 40/Figure 41,
pos. 2).

Figure 40: Detail of the KBox C-102-2 with PCIe riser card with 2x PCIe x4 sockets

Figure 41: Detail of the KBox C-102-2 with PCI-PCIe riser card with 1x PCI (32 bit) and 1x PCIe x4 sockets

1
2
3

Figure 42: Detail of the KBox C-102-4 with PCIe riser card with 4x PCIe x4 sockets

2
1
3
9
10
www.kontron.com
2
1
2
3
KBox C-102 - User Guide, Rev. 1.0
4
5
6
7
5
8
11
5
6
12
13
// 50