Main Setup Menu; Table 2: Main Setup Menu Sub-Screens And Functions - Kontron KBox C-102 Series User Manual

1.2.1.

Main Setup Menu

On entering the uEFI BIOS the Setup program displays the Main Setup menu. This screen lists the Main Setup menu
sub-screens and provides basic system information as well as functions for setting the system language, time and
date. The following table shows Main sub-screens and functions, and describes the content. Default settings are in
bold.
Table 7: Main Setup Menu Sub-screens and Functions
Sub-Screen Description
BIOS Read only field
Information>
Displays information about the BIOS system
Vendor, Core version, Compliancy, Kontron BIOS Version, and Access level
Board Read only field
Information>
Displays Board Information:
Board ID, Fab ID, and LAN PHY revision
Processor Read only field
Information>
Displays Processor Information:
Name, Type, Speed, ID, Stepping, Number of Processors, Microcode Revision, and GT Info
Displays BIOS Version and Memory RC Version Information:
IGFX VBIOS Version, IGFX GOP Version, Memory RC Version Total Memory and Memory
Frequency.
PCH Read only field
Information>
Displays PCH information:
Name, PCH SKU, Stepping, and Hsio Revision
Displays SPI Clock Information:
Read ID/Status Clock Frequency, Write and Erase Clock Frequency, and Fast Read Clock
Frequency, Read Clock Frequency
Displays Firmware Information:
ME FWVersion and ME Firmware SKU
System Selects system default language
Language>
[English]
Platform Read only field
Information>
Displays Module Information
Product Name, Revision, Serial # ‚MAC Addresses (ETH), Boot Counter, and CPLD Rev
Displays Carrier Board Information
Product Name, Revision Serial No., Carrier Board ID
Additional information for MAC Address
The MAC address entry is the value used by the Ethernet controller and may contain the entry'
Inactive' - Ethernet chip is inactive. To activate the Ethernet chip set the following:
Advanced > Network Stack Configuration > Network Stack > Enable
88:88:88:88:87:88 is a special pattern that will be filled in by the Ethernet firmware if there is
no valid entry in the firmware block of the BIOS SPI (i.e. the MAC address has been overwritten
during the last attempt to flash the system). For more information, see chapter 15.3 "Updating
the uEFI BIOS".
www.kontron.com
KBox C-102 - User Guide, Rev. 1.0
// 80