Table of Contents
Advertisement
CP6003-SA
3.5.1
USB Device Installation
The CP6003-SA supports all USB Plug and Play computer peripherals (e.g. keyboard, mouse,
printer, etc.).
Note ...
All USB devices may be connected or removed while the host or other
peripherals are powered up.
3.5.2
SATA Flash Module Installation
A SATA Flash module may be connected to the CP6003-SA via the onboard connector, J17.
This optionally available module must be physically installed on the CP6003-SA prior to
installation of the CP6003-SA in a system.
During installation it is necessary to ensure that the SATA Flash module is properly seated in
the onboard connector J17, i.e. the pins are aligned correctly and not bent.
Note ...
Only qualified SATA Flash modules from Kontron are authorized for use with
the CP6003-SA. Failure to comply with the above will void the warranty and
may result in damage to the board or the system.
3.5.3
Installation of External Serial ATA Devices
The following information pertains to external SATA devices which may be connected to the
CP6003-SA via normal cabling.
Some symptoms of incorrectly installed SATA devices are:
• Device on a SATA channel does not spin up: check power cables and cabling. May also
result from a bad power supply or SATA device.
The SATA connector on the CP6003-SA provides only a data connection. The power for
this device must be supplied by a separate connector. For further information, refer to
the respective documentation of the device.
• SATA device fail message at boot-up: may be a bad cable or lack of power going to the
drive.
3.5.4
Onboard 2.5" HDD/SSD Installation
One 2.5" SATA HDD/SSD may be directly connected to the board via the J17 connector and
the adapter module MMADP-SATA01. This module is required to provide Serial ATA interfacing
to the HDD/SSD. For further information regarding the MMADP-SATA01 module, refer to Ap-
pendix A.
ID 1044-9757, Rev. 2.0
Installation
Page 3 - 9
Advertisement
Table of Contents
