Table of Contents
Advertisement
Legend for Figure 40 and Figure 41:
1
Slot bracket for the for the PCIe 1 expansion slot
2 Screws to secure the expansion slot/cards
brackets
3 Slot bracket for the for the PCIe 2 expansion slot
4 Riser card with 2x PCIe x4 expansion sockets
5 Free PCIe x4 socket (for PCIe 1 slot)
6 Free PCIe x4 socket (for PCIe 2 slot)
7
Riser card with 1x PCI and 1x PCIe x4 expansion
sockets
4.
Insert/remove the expansion card into/from the corresponding PCI/PCIe socket of the corresponding riser card
(Figure 40, pos. 5, pos. 6 or Figure 41, pos. 5, pos. 8).
5.
If you have removed an expansion card, re-insert the slot bracket.
6.
Secure the card or slot bracket to the chassis with the retained fastening screw.
7.
In order to close the KBox C-102-2, proceed in reverse order (step 6 to 1 in the section 6.2).
6.3.6. Installing/Removing the PCIe Mini Card
To install a PCIe mini card please proceed according to the steps described:
1.
Close all applications; shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the device as described in the section 6.2 "Opening and Closing the KBox C-102" (step 1-6).
3.
Locate the PCIe Mini card socket and the corresponding fixing clips (Figure 37, pos. 1).
4.
Insert the PCIe Mini card into the socket (Figure 37, pos. 2) at an angle of approx. 45° and push it down until the
fixing holes of the card are aligned with the fixing clips.
5.
Press the PCIe Mini card down (on the side with the fixing holes) until the card snaps in the fixing clips.
6.
In order to close the KBox C-102, proceed in reverse order (step 6 to 1 of the section 6.2).
To remove a PCIe Mini card please proceed according to the steps described:
1.
Close all applications; shut down the system properly and disconnect the connection to the power source.
Disconnect all peripherals.
2.
Open the device as described in the subsection 6.2 "Opening and Closing the KBox C-102" (step 1-6).
3.
Locate the PCIe Mini card installed into your system.
4.
Slide outwards the fixing clips in order to release the PCIe Mini card. It will spring up at an angle of approx. 45° on
the fixing clips side.
5.
Gently pull the PCIe Mini card out.
6.
In order to close the KBox C-102, proceed in reverse order (step 6 to 1 of the section 6.2).
www.kontron.com
8
Free 1x PCI (32 bit) (for PCIe 2 slot)
9 Slot bracket for the for the PCIe 3 expansion slot
10 Slot bracket for the for the PCIe 4 expansion slot
11 Riser card with 4x PCIe x4 expansion sockets
12 Free PCIe x4 socket (for PCIe 3 slot)
13 Free PCIe x4 socket (for PCIe 4 slot)
KBox C-102 - User Guide, Rev. 1.0
// 51
Advertisement
Table of Contents
