Internal Or Removable 2.5" Sata Hdds/Ssds; Figure 20: Drive 1 And Drive 2 For Removable 2.5" Sata Hdd/Ssd (Option); Closed Drive Bays; Figure 21: Drive Bay 1 With Opened Drive Bay Cover; Figure 22: Inserting/Removing A 2.5" Removable Ssd - Kontron KBox C-102 Series User Manual

4.4.12. Internal or Removable 2.5" SATA HDDs/SSDs

Depending on the ordered system configuration, your KBox C-102-2 can be equipped with up two drive bays for 2.5"
removable SATA HDDs/SSDs (refer to Figure 59, Figure 60 and Figure 20) or one internal mounting frame for
2x 2.5" SATA HDDs/SSDs. The drive bays are suitable for 9.5 mm SSDs and 7 mm SSDs (with adapter).
The internal 2.5" HDDs/SSDs are not accessible from the outside. The internal SATA HDDs/SSDs are installed (always
factory installed) into the system by use of a mounting frame.
The 2.5" drive bays (DRIVE 1 and DRIVE 2) for removable HDDs/SSDs are accessible from the front side (Figure 59) of
the system (refer to Figure 20, Figure 21 and Figure 22).
The drives support following drive speeds:
 DRIVE 1: up to SATA 6 Gb/s.
 DRIVE 2: up to SATA 6 Gb/s.
If the KBox C-102-2 configuration with internal 2.5" SATA HDDs/SSDs was ordered, the
"DRIVE 1" and "DRIVE 2" for removable SATA HDDs/SSDs are not available (refer to Figure 9).
If the KBox C-102-2 configuration with removable 2.5" SATA HDDs/SSDs was ordered, no
installation of any internal SATA HDD/SSD (with mounting frame) is possible.
Refer also to the area marked "D" in the section 4.4.
Figure 20: Drive 1 and Drive 2 for removable 2.5" SATA
HDD/SSD (option); closed drive bays
1

Figure 22: Inserting/removing a 2.5" removable SSD

5
1 Lockable lever to release the drive bay cover
2 Cover of the drive bay
3 Pulled-out lever
Please observe that the KBox C-102-1 system configuration can be equipped with only one
internal or removable 2.5" SATA HDD/SSD. Refer to the chapter 13/ "KBox C-102-1 Variant"
and the subsection 13.1.2 "Internal or Removable 2.5" SATA HDD/SSD".
The KBox C-102-0 can be equipped with only one internal 2.5" SATA HDD/SSD. Refer to the
chapter 14/ "KBox C-102-0 Variant" and the subsection 14.1.1 "Internal 2.5" SATA Drive".
Refer also to the area marked "D" in the section 4.4.
www.kontron.com

Figure 21: Drive bay 1 with opened drive bay cover

3
2
This SATA interface supports hot-
swapping.
4
To prevent data loss, don't remove
the HDD during read/write activity
[while the "DRIVE LED" (Figure 18)
5
is flashing green].
4 Drive bay for 2.5" removable SATA HDD/SSD
5 Opened drive bay cover
6 Inserting or removing a 2.5" removable SATA HDD/SSD
KBox C-102 - User Guide, Rev. 1.0
// 34