Kontron KBox C-102 Series User Manual page 83

Sub-Screen Function
CPU Power
Power and
Performance> management
Control>
(continued)
(continued)
GT Power
management
Control>
PCH-FW Read only fields
Configuration>
ME FW Version, ME Firmware Mode, ME Firmware SKU, ME File System Integrity Value,
ME Firmware Status 1, ME Firmware Status 2 and NFC Support.
ME State>
ME Unconfig ON
RTC Clear>
Comms Hub
Support>
JHI Support>
Core BIOS Done
Message>
Firmware
Update
Configuration>
www.kontron.com
Second level Sub-Screen / Description
Intel® Allows support for more than two frequency ranges
Speedstep ™>
[Enabled, Disabled]
Intel® Speed Intel Speed Shift Technology support. Enable exposes
Shift CPPC v2 interface to allow for hardware controlled
Technology> P-states.
[Enabled, Disabled]
Turbo Mode> Enables or disables Processor Turbo mode. Note:
EMTTM must also be enabled.
Auto means enabled unless the max. turbo ratio is
bigger than 16-SKL A0 W/A.
[Enabled, Disabled]
C-states> Enables or disables CPU power management to allow
CPU to enter C-Sates when not 100% utilized.
[Enabled, Disabled]
Enhanced C- Enables or disables C1E. If enabled CPU switches to
states> minimum speed when all cores enter C-state.
[Enabled, Disabled]
Packaged C- Maximum Package C-State limit setting.
state Limit>
Default: leaves the factory default value.
Auto initializes to deepest available package c-state
limit.
[Auto, CPU Default, C10, C9, C8, C7S, C7, C6, C3, C2, C0/C1]
Thermal Enable/disable thermal monitor
Monitor>
[Enabled, Disabled]
RC6 (Render Check to enable render standby support.
standby)> [Enabled, Disabled]
Maximum GT Maximum GT frequency limited by user.
Frequency> Choose from range 350 MHz (RPN) to 1000 MHz (RPO).
Out of range values are clipped to the minimum and
maximum range values above.
[Default Max Frequency, 100 MHz, – 1200 MHz]
If disabled, ME enters ME temporarily disabled mode.
[Enabled, Disabled]
If disabled, ME is not unconfigured on RTC clear.
Enables or disables ME FW Image RE-Flash function
Support for Comms hub
[Enabled, Disabled]
Enables or disables Intel® DAL Host Interface Service (JHI)
[Enabled, Disabled]
Enables or disables core BIOS done message sent to ME
[Enabled, Disabled]
ME FW Image Enables or disables ME FW Image RE-Flash function
Re-Flash>
[Enabled, Disabled]
Local FW Enables or disables local FW update function
Update>
[Enabled, Disabled]
KBox C-102 - User Guide, Rev. 1.0
// 83