At+Cgdata Enter Data State; At+Cgpaddr Show Pdp Address - Quectel M35 Command Manual

Example
AT+CGDCONT=1,"IP","CMNET"
OK
AT+CGACT=1,1
OK
AT+CGACT=0,1
NO CARRIER

10.6. AT+CGDATA Enter Data State

AT+CGDATA Enter Data State
Test Command
AT+CGDATA=?
Write Command
AT+CGDATA=<L2P>[,<cid>[,<cid>[,...
]]]
Reference
GSM 07.07
Parameter
<L2P> A string parameter that indicates the layer 2 protocol to be used between the TE and MT:
PPP – Point to Point protocol for a PDP such as IP
Other values are not supported and will result in an ERROR response to the execution
command
<cid> A numeric parameter which specifies a particular PDP context definition (see +CGDCONT
command)

10.7. AT+CGPADDR Show PDP Address

AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=?
M35_AT_Commands_Manual
// Define PDP context
// Activated PDP
// Deactivated PDP
Response
+CGDATA: (list of supported <L2P>s)
OK
Response
OK
NO CARRIER
If error is related to ME functionality:
+CME ERROR: <err>
Response
+CGPADDR: (list of defined <cid>s)
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
116 / 186