Mitsubishi Electric MR-JE-*C Instruction Manual page 278

12. WHEN USING WITH A GENERAL-PURPOSE INTERFACE
3) Varying-speed operation
By setting the auxiliary function of the point table, the servo motor speed during positioning can
be changed. Point tables are prepared as many as the number of the set speeds. Refer to
section 7.4 (1) (c) for details. When referring, replace the wording as follows.
Target point table
Controlword bit 4 (New set-point)
Point actual value
4) Automatic repeat positioning operation
By setting the auxiliary function of the point table, the operation pattern of the set point table No.
can be returned to, and the positioning operation can be performed repeatedly. Refer to section
7.4 (1) (d) for details. When referring, replace the wording as follows.
Target point table
Controlword bit 4 (New set-point)
Point actual value
Before replacing
Before replacing
12 - 63
After replacing
Point table No. to select
ST1 (Forward rotation start)
PT0 (Point table No. output 1) to PT7 (Point table No.
output 8)
After replacing
Point table No. to select
ST1 (Forward rotation start)
PT0 (Point table No. output 1) to PT7 (Point table No.
output 8)