Mitsubishi Electric MR-JE-*C Instruction Manual page 167

7. HOW TO USE THE POINT TABLE
(4) Initial setting of point table data (d)
Click "Set to default" to initialize all the data of point table No. 1 to 255. This function also initializes data
currently being edited.
(5) Verifying point table data (e)
Click "Verify" to verify all the data displayed and data of the servo amplifier.
(6) Detailed setting of point table data (f)
Click "Detailed Setting" to change position data range and unit in the point table window. Refer to
section 7.7.2 for details.
(7) Single-step feed (g)
Click "Single-step Feed" to perform the single-step feed test operation. Refer to section 7.1.3 for details.
(8) Copy and paste of point table data (h)
Click "Copy" to copy the selected point table data. Click "Paste" to paste the copied point table data.
(9) Inserting point table data (i)
Click "Insert" to insert a block before the selected point table No. The selected block and later will be
shifted down by one.
(10) Deleting point table data (j)
Click "Delete" to delete the selected block of the point table No. The selected block and later will be
shifted up by one.
(11) Changing point table data (k)
After selecting the data to be changed, enter a new value, and press the Enter key. The displayed
range and unit can be changed with "(6) Detailed setting of point table data" in this section.
(12) Reading point table data (l)
Click "Open" to read the point table data.
(13) Saving point table data (m)
Click "Save As" to save the point table data.
(14) Updating project (n)
Click "Update Project" to update the point table data to a project.
7 - 38