Table of Contents
Advertisement
SECTION 8: QUICK START GUIDE
Landscape or Portrait
You can engrave using either landscape or portrait modes. Depending on the artwork, you can increase your
efficiency and decrease the time it takes to engrave an image by changing the orientation of your file. Many
users set up their artwork in portrait mode and then rotate the artwork 90 degrees if they are going to print
from landscape mode.
300 DPI
600 DPI
This project setup shows the same job in portrait mode (left) and landscape mode (right). The landscape mode will
engrave quicker because there is less turnaround time as the laser makes longer passes across the engraving table. For
example, at 100% speed and 100% power in portrait mode this graphic will take 56 minutes, 56 seconds, while in
landscape mode it takes 38 minutes, 54 seconds, a 34% time savings.
Engraving Time: 56:56
Engraving Time: 38:54
- 81 -
Resolution
Advertisement
Table of Contents
Need help?
Do you have a question about the Fusion M2 32 and is the answer not in the manual?
Questions and answers
laser not accepting print jobs how do I fix this