Windows 8 And 10: Usb Installation - Epilog Fusion M2 32 Manual

SECTION 3: DRIVER INSTALLATION
19. Click Finish and your driver is installed.
20. You must now restart your computer before you
print to the laser.
21. If you will be printing from CorelDRAW, go to
"Setting Up CorelDRAW Beziers Setting" on page
31.
Windows 8 and 10: USB
Installation
Windows 8 will not automatically walk you through
the installation process so it is important to follow the
instructions below.
1. Insert the Epilog driver install disc into your
computer (or download the files from the website).
One of the following screens will appear. For the
USB installation, you will want to close them. We do
not want the computer to automatically try to install
the driver.
2. With the power of your laser turned off, connect the
USB cable to your computer and your Fusion.
3. Power on your laser system. It will take about a
minute for the laser to initialize.
4. Once your laser has initialized, there will not be any
real indication on your computer that it is ready to
install the Epilog driver, but it is ready.
5. In Windows 8, open the Charms Bar and click on the
Search charm. To access the Charms Bar move your
mouse into the lower right corner of your display.
6. Type the word Control into the search bar. Click on
the Control Panel box under Apps in the upper left of
this window. In Windows 10, you can search for this
from the desktop.
7. Click Devices and Printers.
- 28 -

Windows 8 and 10: USB Installation