Epilog Fusion M2 32 Manual page 23

SECTION 2: GETTING STARTED
Most Epilog users will use the IP Address of
192.168.003.004, which is what we use in
this manual.
IP Address
192.168.003.004
4. With CONFIG still selected, tilt the Joystick down
until Subnet Mask appears.
5. Center click to gain access, tilt the Joystick up or
down to increment or decrement. Tilt left or right to
move to the different sets of three numbers. Set the
Subnet Mask to 255.255.255.0. Press the Go key to
make your change permanent.
Subnet Mask
255.255.255.0
8. Set Up TCP/IP Address in the
Computer
Go to your Network and Sharing Center in your computer's
Control Panel.
1. Click Change Adapter Settings.
2. Right click Local Area Connection, then click
Properties.
3. Select Internet Protocol Version 4 (TCP/IP). Make
sure you do not select Version 6.
- 17 -
7. Set the Fusion's IP Address