Emergency Stop Button - Epilog Fusion M2 32 Manual

SECTION 10: SYSTEM FEATURES
1. Set the page size to the area you want to engrave. Unlike
when we used Center-Center, page size is important when
using Page-Center.
2. Center your graphic on the page with the center point you
want to use (the image on the right).
3. In the Laser Dashboard, check the box next to Center
Engraving in the General Tab, then select Page-Center
from the drop-down box. Set the piece size to the size of
the page you created.
4. Set the Home Position as the center of the object you are
engraving using the steps in the previous example.
5. Run the job and you'll have a properly centered image.

Emergency Stop Button

On the front of the laser you will see a large, red Emergency Stop key. If there is an
emergency, such as a fire, immediately press the Emergency Stop key. The laser
carriage will immediately stop and the system will shut down.
To reset the system, you must turn off the system using the regular power switch,
then twist the Emergency Stop key clockwise to release the system, then turn on
the laser.
If your laser ever stops running and you can't turn it on, check to see if
the Emergency Stop key has been pressed by accident.
Emergency Stop Button
Power Switch
- 108 -
Emergency Stop Button