Epilog Fusion M2 32 Manual page 146

SECTION 11: OPTIONAL FEATURES
blue icon. It will turn pink. Click the Proceed key
again in the lower right corner.
10. After clicking the second registration mark the video
feed will show an overlay of vector lines to be cut.
Insure the lines are in the correct location and
orientation. If they are, you are ready to print to the
Fusion.
Confirm and Print using the Proceed key in the lower
right corner. The job will now print to the Fusion.
11. Hunting Routine: The laser carriage will start
moving to find the first registration mark and
precisely locate its exact location on the laser bed.
The same process is followed to precisely locate the
second mark.
After locating the second mark, the carriage will stop
moving while it is directly over the second mark. At
this point, the vector files is transferred to the
Fusion and the Fusion is ready to start cutting.
12. Close the lid of the laser. Click the Go key on the
keypad to start the job. The laser will then move
away from where it stopped over the second
registration mark and start the job.
Quick Print a Job
When you are cutting duplicate prints, you can quickly
move from one piece to the next by using the Quick Print
feature.
1. Quick print is determined by page size, so if you
have set your page to the size of the material, place
your item to be cut as close to the top left corner of
the table as possible.
- 140 -
eView Camera Module