Table of Contents
Advertisement
SECTION 12: UPGRADING THE OPERATIONAL FIRMWARE
Click Print.
At this point, the .hex file will begin transferring to your
laser. The laser knows that it is being upgraded and the
graphic that you created will not print, nor will it show up
as a Job. Instead, the cursor keys will light up. When the
upgrade is complete, the display will read Reboot!
The programing process takes a few minutes
to complete. Do not disturb the laser during
the upgrade process!
After you have rebooted your laser, the process is complete
and you will see the new version number of firmware on
your LCD as the laser powers up.
Depending on the type of upgrade you may be requested
to reboot more than once.
Close your design page and you are ready for you next job!
- 157 -
How to Upgrade Your Firmware
Advertisement
Table of Contents
Need help?
Do you have a question about the Fusion M2 32 and is the answer not in the manual?
Questions and answers
laser not accepting print jobs how do I fix this