Epilog Fusion M2 32 Manual page 13

SECTION 1: SAFETY
3
4
5
6
7
8
9
10
3. Descriptive Label: This label identifies the classification of the Model
13000/14000 in accordance with 21 CFR 1040.10 and IEC 60825-1. It
is located on the left rear of the machine's cabinet, below the Warning
Logotype.
4. Non-interlocked Protective Housing Safety Labels: These labels are located
on, or adjacent to, removable access covers on the machine's cabinet as
shown in the diagrams to follow. Where a label is located on a removable
cover, there is an additional label under the cover so that it will be visible
when the cover has been removed.
5. Defeatably-interlocked Protective Housing Safety Labels: There is one label
on each of the machine's cabinet doors; one on the front door and one on the
top door.
6. Emergency Stop Label: This label is located above the red Emergency Stop
switch on the right front of the
machine's cabinet.
7. Electrical Safety Label: This label is
located on the power supply module,
inside the bay at the lower right-
hand side of the machine.
8. Main Breaker Label: This label
is located on or below the power
module panel at the left rear of the
machine's cabinet.
9. Air Assist Label: This label is located
on the laser bay cover, at the left rear
of the machine's cabinet.
10. Aperture Safety Label: This label is
located above the aperture, inside
the cabinet, where laser beams enter
the machine's engraving area.
11. Power Labels: The appropriate label
for the machine is located on or
above the power module panel at the
left rear of the machine's cabinet.
12. Fire Warning Label: There are
two labels on top of the machine's
cabinet; one to the left and one to the
right of the top cabinet door.
11
- 7 -
Safety Features and Regulatory Compliance
12