Epilog Fusion M2 32 Manual page 156

SECTION 11: OPTIONAL FEATURES
10. Resize the Photo: You must now resize the photo to
the size you want to engrave. With the photo
selected, type in the X and Y dimensions of the
photo.
11. Set the Resolution: This number must match the
resolution at which you will be engraving the photo.
Select Image then Image Size from the menu. Type
in the resolution and select Apply.
Make sure you have selected Apply or the
new resolution will not be saved with the
image.
12. Transform the Photo: With the photo resized and the
resolution set, we are ready to transform the
photograph. From the menu select Transform then
Photo Laser. Choose Interactive to select the
material you want to use. Choosing Automatic will
apply the material settings you used on your last
project.
13. Select the yellow folder to open the materials folder.
14. Choose the material you are going to engrave. If you
don't see the Epilog settings, they can be
downloaded from
instructions.htm.
15. If you want to replace the photograph with the new
1-bit photograph, uncheck Keep Original, otherwise
it will place the transformed image next to your
original on the page. Press the OK key to finish.
- 150 -
PhotoLaser Plus
epiloglaser.com/photolaserplus_