Writing And Starting The Circuit Program; Selecting Programming Mode - Siemens LOGO! Manual

3.7

Writing and starting the circuit program

After you have designed a circuit, you want to write it to your LOGO!. The small example
below shows how to do this.
3.7.1

Selecting programming mode

You have connected LOGO! to the power supply and switched it on. The display now shows
you the message:
Switch LOGO! to programming mode by pressing ESC. This will take you to the main menu
of LOGO!:
The first character in the first line is the ">" cursor. Press
and down. Move it to "Program.." and confirm with OK. LOGO! opens the programming
menu.
Here you can also move the ">" cursor by pressing
and confirm with OK.
Move the ">" cursor to "Edit Prg" (for editing the circuit program) and confirm with OK.
LOGO! now shows you the first output:
LOGO!
Manual, 10/2017, A5E01248535-AA
Programming LOGO!
3.7 Writing and starting the circuit program
and to move the ">" cursor up
and . Move the ">" cursor to "Edit.."
69