Download  Print this page

Advertisement

LOGO! functions
4.4 Special functions list - SF
If you set this message to tick "line by line" with a tick interval of 0.1 seconds, then the initial
appearance of this message on the LOGO! onboard display or LOGO! TD is the left half of
the message as shown in this illustration:
After 1 second (10 x 0.1 second), the message ticks to show the right half of the message as
shown in this illustration:
The screen display alternates between the two message halves every second.
You can configure each individual line of a message text to tick or not tick. The "character by
character" or "line by line" setting applies to all lines that you configure to tick.
Input P configuration
From the input P, you configure the following characteristics of the message text:
● Priority
● Acknowledgement
● Message destination
● Tick type, and tick setting for each line
To configure the priority and the acknowledgment (programming mode):
1. Increase the priority to 1: Cursor on '0' +
2. Change to 'Ack': Press
3. Enable 'Ack': Press
LOGO! shows:
184
or
Manual, 10/2017, A5E01248535-AA
LOGO!

Advertisement

   Also See for Siemens LOGO!

   Related Manuals for Siemens LOGO!

Comments to this Manuals

Symbols: 0
Latest comments: