Wall-Mounting - Siemens LOGO! Manual

LOGO! installation and wiring
2.2 Installing/removing LOGO!
Repeat steps 1 to 4 for all other expansion modules.
Note
If you have connected more than one expansion module, it is advisable to start removal with
the last module at the right-hand side.
Make sure the slide interlock of the module to be installed/removed is not engaged in the
next module.
2.2.2

Wall-mounting

For wall-mounting, first slide the mounting slides on the rear side of the devices towards the
outside. You can now wall-mount LOGO! by means of two mounting slides and two Ø M4
screws (tightening torque 0.8 to 1.2 Nm).
34
Manual, 10/2017, A5E01248535-AA
LOGO!