Compatibility; Installing/Removing Logo - Siemens LOGO! Manual

2.1.3

Compatibility

The LOGO! TD module can only be used with equipment series 0BA6.
You cannot edit message texts from the LOGO! Base Module that contain any of the
following parameters:
● Par
● Time
● Date
● EnTime
● EnDate
You can only edit such message texts from LOGO!Soft Comfort.
When using the LOGO! AM2 AQ analog module with equipment series 0BA4 or 0BA5, the
functions are limited to the ones available on this equipment. You cannot use the module
with equipment series 0BA3 or earlier.
All other expansion modules are completely compatible with the LOGO! Base Modules of
equipment series 0BA3, 0BA4, 0BA5, and 0BA6.
2.2

Installing/removing LOGO!

Dimensions
The LOGO! installation dimensions are compliant with DIN 43880.
LOGO! can be snap-mounted to 35 mm DIN rails to EN 50022 or on the wall.
LOGO! width:
● LOGO! TD has a width of 128.2 mm, which corresponds to 8 subunits
● LOGO! Base Modules have a width of 72 mm, which corresponds to 4 subunits
● LOGO! expansion modules have a width of 36 mm or 72 mm (DM16...), which
corresponds to 2 or 4 subunits
Note
The figure below shows you an example of the installation and removal of a LOGO! 230
RC and a digital module. The measures shown apply to all other LOGO! Base Module
versions and expansion modules.
Always switch off power before you remove or insert an expansion module.
LOGO!
Manual, 10/2017, A5E01248535-AA
WARNING
LOGO! installation and wiring
2.2 Installing/removing LOGO!
31