Din Rail Mounting - Siemens LOGO! Manual

LOGO! installation and wiring
2.2 Installing/removing LOGO!
2.2.1

DIN rail mounting

Mounting
How to mount a LOGO! Base Module and a digital module onto a DIN rail:
1. Hook the LOGO! Base Module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
3. On the right side of the LOGO! Base Module/LOGO! expansion module, remove the
connector cap.
4. Place the digital module onto the DIN rail on the right-hand side of the LOGO! Base
Module.
5. Slide the digital module towards the left until it contacts the LOGO! Base Module.
6. Using a screwdriver, push the interlock to the left. In its end position the slide interlock
engages in the LOGO! Base Module.
32
Manual, 10/2017, A5E01248535-AA
LOGO!