Download  Print this page

Advertisement

LOGO! memory and battery cards
6.1 Security function (CopyProtect)
LOGO! shows the following display:
The current protection setting is shown in the bottom line. This function is disabled by default
("No": disabled).
Enabling the security function
To set the security function:
1. Move the '>' cursor to 'Yes': Press
2. Confirm 'Yes': Press OK
LOGO! shows the following display:
Note
This only generates a circuit program and copy protection for the memory card or combined
memory/battery card; the circuit program itself must be copied (Page 233) separately from
LOGO! to the memory card or combined memory/battery card. (This copy can be done at
power-on.)
You can always change the "No" status (security function disabled) to "Yes" (security
function enabled).
A status change from "Yes" (security function enabled) to "No" (security function disabled) is
only possible if the memory card or combined memory/battery card does not contain a circuit
program.
230
or
Manual, 10/2017, A5E01248535-AA
LOGO!

Advertisement

   Also See for Siemens LOGO!

   Related Manuals for Siemens LOGO!

Comments to this Manuals

Symbols: 0
Latest comments: