Writing And Starting The Circuit Program; Selecting Programming Mode - Siemens Logo! Manual

3.7 Writing and starting the circuit program

After you have designed a circuit, you want to write it to
your LOGO! . The small example below shows how to do
this.

3.7.1 Selecting programming mode

You have connected the LOGO! to the power supply and
switched it on. The display now shows you the message:
No Program
Press ESC
Switch the LOGO! to programming mode by pressing the
ESC. This will take you to the main menu of the LOGO!:
>Program..
Card..
Setup..
Start
The first character in the first line is the ">" cursor. Press
and
gram.." and confirm with OK. LOGO! opens the program-
ming menu.
>Edit..
Clear Prg
Password
LOGO! Manual
A5E00380835-01
to move the ">" cursor up and down. Move it to "Pro-
Programming LOGO!
LOGO!'s main menu
The LOGO!'s programming menu
69