Copying Data From The Memory Card To Logo - Siemens LOGO! Manual

LOGO! memory and battery cards

6.4 Copying data from the memory card to LOGO!

6.4 Copying data from the memory card to LOGO!
You can copy a circuit program from a compatible memory card or combined
memory/battery card to LOGO! in one of two ways:
● Automatically during the startup of LOGO! (POWER ON)
● By means of the "Card" menu of LOGO!
Note
If the program on the module/card is protected with a password, the copied program in
LOGO! is also protected with the same password.
Automatic copying during the startup of LOGO!
Proceed as follows:
1. Switch off the power supply to LOGO! (POWER OFF)
2. Remove the slot cover.
3. Insert the program module/card into the relevant slot.
4. Switch on the power supply to LOGO!
LOGO! copies the program from the program module/card to LOGO!. (If the memorycard
is from an incompatible 0BA0..0BA3 version, LOGO! displays this message: "Unknown
Card / Press ESC".)
When LOGO! has finished copying, it opens the main menu:
Note
Before you switch LOGO! to RUN, you must ensure that the system you are controlling
with LOGO! does not represent a source of hazard.
5. Move the '>' cursor to 'Start': Press
6. Press OK.
234
or
Manual, 10/2017, A5E01248535-AA
LOGO!