Siemens LOGO! Manual page 84

Programming LOGO!
3.7 Writing and starting the circuit program
You can see the OR block and the output relay Q1 we have already used in the first circuit
program. The only difference is the new off-delay block.
Editing the circuit program
Switch LOGO! to programming mode.
As a reminder:
1. Switch LOGO! to programming mode
(in RUN: Press ESC to enter the parameter assignment mode. Select the 'Stop'
command, confirm with OK, then move the '>' cursor to 'Yes', and once again confirm
with OK). For additional details, see the topic "The four golden rules for operating LOGO!
(Page 66)".
2. On the main menu, select "Program"
3. On the Programming menu, select "Edit", confirm with OK. Next, select "Edit Prg" and
confirm with OK.
If required, enter your password at the prompt and confirm with OK.
You can now modify the current circuit program.
Adding a block to a circuit program
Move the cursor to the B in B1 (B1 is the number of the OR block):
We now insert the new block at this position.
Confirm with OK.
Press
84
to select the SF list:
Manual, 10/2017, A5E01248535-AA
LOGO!