LOGO! installation and wiring
2.2.1 DIN rail mounting
Mounting
How to mount a LOGO! Basic and a digital module onto a
DIN rail:
LOGO! Basic:
1. Hook the LOGO! Basic module onto the rail and
2. then push down the lower end to snap it on. The
mounting interlock at the rear must engage
LOGO! digital module:
3. On the right side of the LOGO! Basic/LOGO! expansion
module, remove the connector cap
4. Place the digital module onto the DIN rail on the
right-hand side of the LOGO! Basic
5. Slide the digital module towards the left until it contacts
the LOGO! Basic
24
1
2
6
3
5
4
A5E00380835-01
LOGO! Manual