Remote Reference (Ref) Indicator; Run Indicator; Stop Indicator - YASKAWA F7 User Manual

http://www.aotewell.com

REMOTE Reference (REF) Indicator

The status of the "REMOTE" Reference (REF) indicator is shown in Table 3.4. This indicator is always "Off" when the Drive
is in the "LOCAL" mode. When the Drive is in the "REMOTE" mode, the REF indicator status is dependent on the setting of
parameter b1-01 (Frequency Reference Selection). See Table 3.4.
Indicator Status
On
Off

Run Indicator

The status of the "RUN" indicator is shown in Table 3.5 when the Drive is in either the "LOCAL" or "REMOTE" mode.
Indicator Status

Stop Indicator

The status of the "STOP" indicator is shown in Table 3.6 when the Drive is in either the "LOCAL" or "REMOTE" mode.
Indicator Status
On
Blinking
Off
Tel: +(86) 755 8660 6182
Table 3.4 REMOTE Reference (REF) Indicator
Parameter b1-01 (Frequency Reference Selection) is set to terminal strip, communications, option
board, or pulse train as indicated below:
b1-01=1 (Terminals)
=2 (Communications)
=3 (Option PCB)
=4 (Pulse Train)
Parameter b1-01 (Frequency Reference Selection) is set to digital
operator as indicated below:
b1-01=0 (Operator)
Table 3.5 RUN Indicator
On
Blinking
Off
Table 3.6 STOP Indicator
Drive is decelerating to a stop or stopped.
Drive is in a run condition but the frequency reference is less than the
minimum output frequency E1-09, or the Drive is running in "REMOTE" mode and the "STOP"
key on has been pressed.
Drive is running.
Aotewell
Condition
Drive is running.
Drive is decelerating to a stop.
Drive is stopped.
Digital Operator 3 - 5
Aotewell
Email: Sales@aotewell.com
Condition
Condition
http://www.aotewell.com